TOZEN PTM-DS mounts are typically used to reduce the transmission of noise and vibration into supporting structures from equipment carrying a large fluid load that may be drained, such as boilers and chillers, and for the isolation of cooling towers, air cooled condensers, etc, which also require hold down for wind loads.

TOZEN PTM-GP vibration isolator is one-piece moulded neoprene with one cast-in load transfer steel plate at the top and base-plate at the bottom. The rubber is loaded in both shear and compression to provide the desirable straight-line rubber-in-shear deflection curves as well as overload protection. The rubber-ribbed bass-plate provides skid resistance and need not be bolted to the floor on most installations.

TOZEN PTM-G vibration isolator is one-piece moulded neoprene with two cast-in load transfer steel plates incorporate with bolt, spring washer and lock nut at the top and the bottom load surface for attachment to support equipment. The synthetic rubber compund is oil resistant and has been designed to operate within the strain limits of the isolator to provide the maximum isolation and longest expectancy. It is recommended for the isolation of vibration produced by small pumps, vent sets, low pressure packaged air handling units, etc., and usually selected when first cost must be minimized.

TOZEN PTH-S Series vibration isolating hangers consists of a rectangular steel box incorporated with a free standing, laterally stable steel spring with load transfer steel cup with rubber washer. PTH-S hangers are used to isolate suspended sources of both auditable and inaudible noise and vibration. Suspended mechanical equipment such as in-line fans, cabinet fans, and piping and ductwork in close proximity to mechanical equipment,